[Xorp-users] Newbie problem with xorpsh
Atanu Ghosh
atanu@ICSI.Berkeley.EDU
Wed, 03 Aug 2005 20:54:57 -0700
Hi,
We don't have any experience with UML so its not clear what has
failed.
You should note that the xorpsh expects to see the same view of the file
system that the rtrmgr sees. In particular the templates directory needs
to be accessible, also many of the xorpsh commands run external
programs. Is it possible that in your guest environment some of these
files are missing?
Atanu.
>>>>> "Chip" == Chip Wang <Wang> writes:
Chip> I installed xorp-1.1 on my UML setup. I compiled it separately
Chip> for the host and the guests. Xorp would start and run on my
Chip> host and guests. I only configured the RIP protocol. It
Chip> appears to distribute the routes among all my virtual (TAP)
Chip> interfaces.
Chip> However, I could only use show interfaces in xorpsh. All other
Chip> show commands, including host rip route would produce
Chip> ERROR: no matching command
Chip> What was wrong?
Chip> Chip The information contained in this e-mail message is
Chip> PRIVATE. It may contain confidential information and may be
Chip> legally privileged. It is intended for the exclusive use of
Chip> the addressee(s). If you are not the intended recipient, you
Chip> are hereby notified that any dissemination, distribution or
Chip> reproduction of this communication is strictly prohibited. If
Chip> the intended recipient(s) cannot be reached or if a
Chip> transmission problem has occurred, please notify the sender
Chip> immediately by return e-mail and destroy all copies of this
Chip> message.
Chip> Thank you.