[Xorp-users] OSPF Areas and Linux Route table
Atanu Ghosh
atanu at ICSI.Berkeley.EDU
Fri Feb 29 23:52:25 PST 2008
Hi,
The output of "show ospf4 neighbor" would be a useful starting point
to verify that the adjacencies have been correctly formed.
Atanu.
>>>>> "Sukrit" == Sukrit Dasgupta <sd88 at drexel.edu> writes:
Sukrit> Hi list, I have a pretty simple setup of 3 areas using OSPF:
Sukrit> 12.0.0.0 (Area1: XORP on Linux)<---------->14.0.0.0 (Area 0:
Sukrit> Cisco 7200 Testbed) <-----------------> 16.0.0.0 (Area 2:
Sukrit> XORP on linux)
Sukrit> The XORP border routers in Area 1 and Area 2 can ping the
Sukrit> Cisco ABR routers, but thats about it. The linux route table
Sukrit> shows that only an entry for the corresponding area. So for
Sukrit> example, $route -e on the XORP with router with IP 12.0.11.2
Sukrit> connected to the Cisco 7200 with IP 12.0.11.3 only shows
Sukrit> Destination Gateway Genmask Flags MSS Window irtt Iface
Sukrit> 12.0.11.0 * 255.255.255.0 U 0 0 0 eth1
Sukrit> No OSPF area information is being shared amongst the
Sukrit> routers.
Sukrit> Any ideas?
Sukrit> Thanks in advance Sukrit
Sukrit> _______________________________________________ Xorp-users
Sukrit> mailing list Xorp-users at xorp.org
Sukrit> http://mailman.ICSI.Berkeley.EDU/mailman/listinfo/xorp-users
More information about the Xorp-users
mailing list