[Xorp-users] Virtual IP on Router Cluster
Pavlin Radoslavov
pavlin at ICSI.Berkeley.EDU
Wed Jul 16 18:40:36 PDT 2008
Bruce M Simpson <bms at incunabulum.net> wrote:
> Dirk H. Schulz wrote:
> > Well, the interfaces are configured as "default-system-config" in the
> > interfaces {} block, the fea {} block contains only the forwarding
> > config, and the ip addresses are configured in the ospf4 {} block of
> > the protocols {} block. I have taken that from the "Getting Started"
> > document on xorp.org.
> > Do you suppose to use a different structure?
According to the XORP User Manual (Section 8.3 Configuring OSPF,
page 84):
---------------------
The OSPFv2 and OSPFv3 configurations are practically equivalent with
the following exceptions:
...
* OSPFv2 supports a single address per interface/vif, therefore all
parameters are set below the address node.
---------------------
In other words, you can't have more than one IP address in the
ospf4 block.
You might want to rethink your setup and see whether you can achieve
it with a single OSPF address.
Pavlin
> Please try manual configuration -- it's entirely possible that XORP may
> be somehow confused by the type of interface the Linux kernel exposes to
> the FEA for the Linux-HA interface.
>
> I'd be interested to know if other folk have had similar experiences
> with FreeVRRP or CARP.
>
> >
> > And the question remains: How do I make an additional IP address on a
> > certain interface known to xorp?
>
> A single vif can have multiple IP addresses; please refer to the user
> manual for configuration of multiple IP addresses.
>
> thanks!
> BMS
>
>
> _______________________________________________
> Xorp-users mailing list
> Xorp-users at xorp.org
> http://mailman.ICSI.Berkeley.EDU/mailman/listinfo/xorp-users
More information about the Xorp-users
mailing list