[Xorp-users] XORP IGMPv3 is not accepting the report with source IP 0.0.0.0
Bruce M Simpson
bms at incunabulum.net
Tue Jul 22 07:18:38 PDT 2008
Hi,
Tushar Mehta wrote:
> according to rfc-3376:
> An IGMP report is sent with a valid IP source address for the
> destination subnet. The 0.0.0.0 source address may be used by a
> system that has not yet acquired an IP address. Note that the
> 0.0.0.0 source address may simultaneously be used by multiple systems
> on a LAN. Routers MUST accept a report with a source address of
> 0.0.0.0.
That's correct, it's a workaround for multicast end-stations which have
not yet obtained IP addresses. It went away in MLDv2/v3 because
link-local IPv6 addresses MUST be used for MLD traffic.
>
> but in my case it is showing me this error message on the terminal
> "source must be unicast"....
> XORP is accepting my IGMPv3 report with source IP address "0.0.0.0".
> what is the problem with XORP or in my setup?
Once again: can you please tell us which operating system, version of
XORP, etc you are using?
I don't see anything obviously wrong with your configuration file,
although your robustness variable is set to 5, which is quite high: is
this intentional, i.e. is it a very lossy network medium?
Please don't send RFCs as attachments to the list.
thanks
BMS
More information about the Xorp-users
mailing list