[Xorp-users] Help !
Bruce Simpson
bms at incunabulum.net
Fri May 1 08:46:30 PDT 2009
Hi there,
I'm assuming you're working with the XORP 1.6 release sources, and are
trying to configure RIPv2 on two interfaces.
JESUS RAMIREZ wrote:
>
> Hello eveybody ...
> Good Morning, I'm rookie in this ,but I think it's very interesting
> and I want to learn, so I have a lot a questions for you.
>
> If I want to configure 2 network cards ( Ethernet ) were can i
> found the configuration ? I read the manual and i dont konw how can i
> get into the code? or do i need to download from your web and then
> paste it, because i need to configure de rip too....if i need to
> download any file were can i found ? and how can i paste it ?
>
> I don't know if any of you guys can Help me..... please : (
>
Probably the best thing for you to do is to look at this file (asuming
you have downloaded xorp-1.6.tar.gz and untarred it) :-
cd xorp-1.6
cd rtrmgr/config
and then view the file "rip.boot" in your favorite text editor.
The configuration for RIP in that file contains two interfaces dc0 and
dc1. You will probably want to edit this for use on whatever operating
system you're trying to run XORP on. In the case of Linux, you can just
use search and replace to change dc0 to eth0, dc1 to eth1, and then fill
out your IP addresses.
After that, configuring RIP should just be a matter of following the
instructions in the User Manual to give RIP the settings you need for
your network.
thanks,
BMS
More information about the Xorp-users
mailing list