[Xorp-users] OSPF point-to-multipoint issue
Ben Greear
greearb at candelatech.com
Fri Jun 18 11:51:53 PDT 2010
On 06/18/2010 11:43 AM, Vincent, Michael - 0665 - MITLL wrote:
> Yes, show interfaces shows the interface in question (the ones OSPF does peering on) as ENABLED.
>
> Additionally, if we exit from xorpsh and remove the offending host routes from linux (route del x.x.x.x) (the ones Xorp OSPF should be removing when OSPF converges) the OSPF sessions are re-established. This is further feeding my belief that Xorp is not properly removing OSPF routes during OSPF convergence.
Ahh, so to get to the original peer, it needs to first remove the routes on the secondary link?
Maybe xorp doesn't bother removing routes until it establishes FULL access with the
new router, which would be a neat catch-22 scenario in your case.
Can you post the results of 'show ospf4 neighbor'
for each of your steps:
* Initial config (This is working OK, right)
* First link failure (And this is OK too)
* Second link failure ( But this fails to switch back to initial config setup??)
Thanks,
Ben
--
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc http://www.candelatech.com
More information about the Xorp-users
mailing list