[Xorp-users] Fwd: underlying vif is not UP

[hilal chouman]

 Almost like this:

vif rl0 {

address 10.0.82.1 {
prefix-length 25
multicast-capable true

}

}
vif rl1 {

address 10.0.83.10 {

prefix-length 25

multicast-capable true

}

}


Note here that both interfaces are enabled and multicast capable, and when I
show the interfaces in the operational mode, the broadcast addresses are
detected and shown as well.

Regards,



On 10/21/06, Pavlin Radoslavov <pavlin at icir.org> wrote:
>
> > The exact error message is as I stated:
> > "101 command failed Cannot enable vif rl0 no such vif"
> > I configured the interfaces and the fea (for unicasting), and I was able
> to
> > commit the changes without errors, When I reached the mfea4 and I
> configured
> > it and tried to commit the changes, the previously stated error occured.
> > I didn't proceed to configure the igmp or the pim-sm or fib2mrib since I
> got
> > this error.
> > Note here that both interfaces are enabled in mfea4 in addition to
> > traceoptions and vif register_vif.
> > I read that vif register_vif must be enabled in case PIM-SM is used, so
> > since I did not configure PIM-SM yet, does that lead to such an erro
> when I
> > enable it??
> >
> > Here is the plumbing configuration:
>
>
> Your MFEA configuration looks fine. What your "interfaces" section
> looks like.
>
> Regards,
> Pavlin
>
> > plumbing {
> >
> > mfea4 {
> >
> > disable: false
> >
> > interface rl0 {
> >
> > vif rl0 {
> >
> > disable: false
> >
> > }
> >
> > }
> >
> > interface rl1 {
> >
> > vif rl1 {
> >
> > disable: false
> >
> > }
> >
> > }
> >
> > interface register_vif {
> >
> > vif register_vif {
> >
> > disable: false
> >
> > }
> >
> > }
> >
> > traceoptions {
> >
> > flag all {
> >
> > disable: false
> >
> > }
> >
> > }
> >
> > }
> >
> > }
>



-- 
Hilal Chouman
هلال شومان
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.ICSI.Berkeley.EDU/pipermail/xorp-users/attachments/20061021/6b76844c/attachment.html