[Xorp-users] PIM/SM: Missing Join and Register-Stop from RP
Ben Greear
greearb at candelatech.com
Thu Mar 13 10:44:48 PDT 2014
On 03/13/2014 10:31 AM, Holger Kummert wrote:
>
> Hello,
>
> I do not understand XORP's behavior when running PIM/SM and Register
> messages (that encapsulate multicast traffic) are received by the
> RP from S.
> What I am really missing is the Join msg towards S in order to avoid
> the encapsulating overhead. Therefore the Register-Stop (in order to
> stop sending the Register msgs) is also not sent by RP.
>
> Shouldn't both messages be sent according to RFC 4601, ch. 3.2?
>
> The only situation where I could force the Register-Stop to be sent
> was by enabling and setting 'switch-to-spt-threshold' to '0'.
> This sending is independent of any Join'ed receivers and happens
> immediately after the receive of the first Register message.
> But this is obviously not the intended usage.
>
> Anyhow under no circumstances any Join messages are sent by RP to S.
>
> Could someone give more insight on this?
I'm afraid I never knew much about multicast, and what I did learn
while hacking on xorp mcast logic I have mostly forgotten.
But, if you figure out a patch that makes xorp work better,
please post it and I will try to review it.
Thanks,
Ben
>
>
> Thanks in advance,
> Holger
>
> _______________________________________________
> Xorp-users mailing list
> Xorp-users at xorp.org
> http://mailman.ICSI.Berkeley.EDU/mailman/listinfo/xorp-users
>
--
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc http://www.candelatech.com
More information about the Xorp-users
mailing list